G750
.75A (750mA)
6V & 12V Multi-Purpose Battery Charger
G750 TECHNICAL SPECIFICATIONS
| Input Voltage AC | 110-120 VAC, 50-60Hz |
| Working Voltage AC | 85-130 VAC, 50-60Hz |
| Input Current | 300mA RMS Max |
| Efficiency | 85% Approx. |
| Power | 20W Max |
| Charging Voltage | 7.2V/14.4V |
| Charging Current | 750mA |
| Back Current Drain | <5mA |
| Ripple | <2% |
| Ambient Temperature | 0°C to +40°C |
| Charger Type | 5 Step, Fully Automatic,
Switch-Mode |
| Type of Batteries | 6V & 12V Lead-Acid |
| Battery Chemistries | Wet, Gel, MF & AGM |
| Battery Capacity | 1.2-30Ah, Maintains All Battery Sizes |
| Housing Protection | IP60 |
| Cooling | Natural Convection |
| Noise Level | <50dB |
| Dimensions (L x W x H) | 4.5 x 2.7 x 1.3 Inches |
| Weight | 0.5 Pounds |
WHAT'S IN THE BOX
- G750 Charger
- Battery Clamp Connectors
- Eyelet Terminal Connectors
- Owner's Manual & User Guide
- Product Registration Card
CHARGING TIMES
The time required for the G750 to charge a normally discharged battery is shown below. Deeply discharged batteries may take longer to charge depending on the depth of discharge (DOD). The charge time is based on an average depth of discharge to a fully charged battery.
Note: The above table is for reference purposes only. Actual data may differ due to battery conditions. The time required for the G750 to charge a normally discharged battery is based on an average DOD of 50%.
CHARGING STEPS
Step 1: Diagnostics
Checks the battery voltage to make sure battery connections are good and the battery is in a stable condition before beginning the charge process.
Step 2: Soft Start
Begins Bulk charging process with a gentle (soft) charge.
Step 3: Bulk
Continues Bulk charging process, returns 90% of battery capacity.
Step 4: Absorption
Brings the charge level to 100%. The battery charger will deliver small amounts of current to provide a safe, efficient charge and limit battery gassing.
Step 5: Maintenance
Monitors the battery voltage continuously to determine if a maintenance charge should be initiated. If the terminal voltage falls below approximately 6.4V (6V) and
12.8V (12V), the charger will start the Maintenance cycle until voltage reaches approximately 7.2V (6V) and 14.4V (12V) and then will discontinue the charge cycle.
Maintenance cycle is repeated indefinitely to keep the battery at full charge, without overcharging. The battery charger can be left connected indefinitely.
CONFORMS TO UL STD. UL1236 CERTIFIED TO CSA STD. C22.2 No.107.2